Druck ADTS 505 User Manual 6 - 21
K0260 Issue No. 8
6
Power-up routine
• Set the power supply switch to ON.
• Check that the screen shows the correct display for a successful power-up.
Check:
¤ the pump operates.
¤ the power indicator lights
¤ air discharges through the water drain.
• Connect the cable to the AHT communication connector on the ADTS 505.
• Check that the screen shows the correct display.
• Check that the ADTS 505 screens show the correct display messages.
Note: This Windows-based facility hides many of the normal features of Windows.
FIGURE 6-5 POWER-UP DISPLAYS
To Next Page
Loading...
