3 - 4 Operation
K0260 Issue No. 8
3.4 First Time Operators
The following sequences of operation should be used by first time operators and by operators that
use the equipment occasionally. For regular users, familiar with the equipment, go to section 3.5.
Set the power supply switch to ON and the power-on routine starts.
(1) The display first shows:
(2) After approximately five seconds the display shows
the start of the power-on sequence, the system
carries out a self test. If the test finds a fault, the
display shows an error message, refer to Section 5,
Fault Finding and Testing.
(3) The display messages show a sequence of
pneumatic and internal system checks:
(4) After a successful self-test sequence the system changes to measure mode. The display changes
to the Leak Measure mode display showing the parameters selected in set-up.
To Next Page
Loading...
