6 - 14 Reference and Specification
K0260 Issue No. 8
• After manufacture the ADTS 505 only contains the pre-defined limit sets. To create the first
user-defined set, use the to step down the list. At the bottom of the list press again,
select [Modify Name], F5 and using the seven screens of characters compose the name of
the new limit set, press ENTER. Select [Modify Details], F4, set the units (aeronautical and
pressure) to be used and, after each entry of a completed value, press ENTER.
ARINC Limits
• The ARINC 565 limit can be selected ON or OFF in a set of user defined limits. When selected,
the values entered and/or achieved in control mode are checked within the operating
envelope of the ARINC 565 limits.
F
IGURE 6-1 ARINC 565 LIMITS GRAPH
To Next Page
Loading...
