3 - 6 Operation
K0260 Issue No. 8
3.4.1 Operating Modes
The air data test system can now be set for a variety of functions and modes. In the following,
examples of measure mode, control mode, leak measure mode and go-to-ground show the key
presses and selections required for each mode.
Measure Mode
The system automatically enters measure mode after a successful self-test. To change the display
press:
To store display for the next power-up press:
To return to measure mode press:
To set the display to show [Monitor]
or [Message] press F6. This switches
between the two settings and
operates only when the hand
terminal is connected.
To Next Page
Loading...
