GE Druck ADTS 505

Druck ADTS 505 User Manual 6 - 41
K0260 Issue No. 8
6
6.5 Specification
Physical Specification
Conformity
Environmental conditions
Pressure/Vacuum Requirements
Pressure connections
Ps ................................................... .............................................................. ............ ..... AN-4, 37° flare
Pt.................................................... .............................................................. ............ ..... AN-4, 37° flare
Performance
The ADTS 505 at a control set-point operating into a leak tight system, consumes no air. The integral
pump is capable of the following:
Rate of climb ............ ............6,000 ft/min into 4 litre (240 cu.in) to 30,000 ft
Rate of speed ............ ............300 knots/min into 2 litre (120 cu.in) to 650 knots
Note: These rates of change decrease for larger volumes.
Size 265 mm x 520 mm x 355 mm (10.4” x 20.5" x 14")
Weight 15 kg [33 lb]
EMC EN 61326 (refer to the declaration of conformity for details)
Electrical safety EN61010-1
Pressure safety Pressure Equipment Directive - class: sound engineering practice (SEP)
Shock and vibration MIL-T-28800 Class 2
For indoor and outdoor
use
Operating altitude Up to 2,290 metres (7,500ft)
Operating temperature 0°C to 50°C (32° to 122°F)
Storage and shipping
temperature
-20°C to 70°C (-4° to 158°F)
Calibrated temperature
range
+5° to +35°C (+41° to +95°F)
Operating humidity 0 to 90% RH (non-condensing)
Vibration MIL-PRF-28800 Type 2 class 5 style E/F
Power Supply Auto-selection between:
100/120/230 Vac, 50/60 Hz
Power - 200 VA
115 Vac, 400 Hz
Power - 200 VA
Transient over-voltages up to the levels of Overvoltage Category II
Pollution degree 2