GE Druck ADTS 505

Druck ADTS 505 User Manual 6 - 11
K0260 Issue No. 8
6
6.3 SETUP
Set-up allows access to secondary functions that do not have an assigned key and are not
part of the main menu.
6.3.1 Set-up 1 of 2
[Display], [Single, Dual, Quad, Hand Term]
In leak measure mode, after each parameter, the display shows "Leak Measure". In control
mode the display changes to Aim = after each parameter.
• Single
The display shows a single parameter. When set, pressing a key-pad function key, the
display changes the displayed parameter. The display will not change if RATE is pressed
when ROC/RtPs is displayed.
• Dual
The display shows two parameters only one can be a rate. The display will not show RtCAS
and ROC/RtPs together and automatically changes to show CAS or ALT respectively. The
display highlights the last selected parameter.
• Quad
The display shows four parameters, pressing a key-pad function key, changes a displayed
parameter and causes the display to highlight the last selected parameter.
• Hand Term
This option has two display settings, see paragraph 6.4 for details.