GE Druck ADTS 505 - Page 113

Druck ADTS 505 User Manual 6 - 33
K0260 Issue No. 8
6
Example Test Table
Note: The pressure and aero units shown have been validated for these procedures. Using any
other units in an up-loaded file may not be accepted by the advanced hand terminal.
Test Identifier
Begin Test Table
Parameter Label
Prompt Message
<TEST TABLE TITLE 1>
<HEADER 1>
<HEADER 2>
REF (a)
REF (b)
<TEST DESCRIPTOR (a)>
<TEST DESCRIPTOR (b)>
<MESSAGE (a)>
<MESSAGE (b)>
Test Identifier
Begin Test Table
Parameter Label
Prompt Message
Case Leak Test
TP
Max. Allowed Leak Rate
1
2
+/- 100 feet/min
End of Test
When stable> Leak Measure>
Go to ground
Ps1 Aim Ps1 RatePs2 Aim Ps2 RatePt Aim Pt Rate
<AIM UNIT> <AIM UNIT> <AIM UNIT> <RATE UNIT> < UNIT>RATE < UNIT>RATE
<Ps1 Aim (a)>
<Ps1 Aim (b)>
<Ps1 Aim (c)>
<Ps1 Aim (d)>
<Ps1 Aim (e)>
<Ps1 >
Rate (a)
<Ps1 > (b)Rate
<Ps1 > (c)Rate
<Ps1 > (d)Rate
<Ps1 > (e)Rate
<Ps2 Aim (a)>
<Ps2 Aim (b)>
<Ps2 Aim (c)>
<Ps2 Aim (d)>
<Ps2 Aim (e)>
<Ps2 >
(a)Rate
<Ps2 > (b)Rate
<Ps2 > (c)Rate
<Ps2 > (d)Rate
<Ps2 > (e)Rate
<Pt Aim (a)>
<Pt Aim (b)>
<Pt Aim (c)>
<Pt Aim (d)>
<Pt Aim (e)>
<Pt (a)> Rate
<Pt (b)> Rate
<Pt (c)> Rate
<Pt (d)> Rate
<Pt (e)> Rate
Ps1 Aim Ps1 RatePs2 Aim Ps2 RatePt Aim Pt Rate
feet feet knots
feet/min feet/min knots/min
18000 600000 0
300
0 600000 0
300
Pressure Units
(for Ps, Pt, Qc)
Assumed Rates
for Pressure Units
mbar
mbar/min
inHg
inHg/min
psi/min
psi
mmHg
mmHg/min
inH2O4C
inH2O20C
InH2O60F
kPa
hPa
inH2O4C/min
inH2O20C/min
inH2O60F/min
kPa/min
hPa/min
Aero Units
(for Altitude and Speed)
Matching Rate
of Aero Units
feet
feet/min
For Altitude:
m/min
For Speed:
knots
knots/min
kph
kph/min
mph
mph/min
Mach knots/min
m
Aero Units
for Altitude
Matching Speed
Units
feet
knots
feet
mph
m
kph
Any of the above
Mach