Generic Formulation Maximum Concentration
Hydrogen Peroxide 6%
Cavicide
®
100% spray (sprayed on a cloth - not directly on the equipment)
Active ingredients: Diisobutylphenoxyethoxyethyl dimethyl benzyl ammonium
chloride (0.28%), Isopropanol (17.20%), inert ingredients (82.54%)
Quaternary Ammonium 0.28%
Isopropyl Alcohol <15%
Do not use the following cleaners; they will damage the parts you are cleaning and are not recommended:
• Isopropyl Alcohol (in concentrations greater than 15%)
• Solvents (such as acetone)
• Wescodyne
NOTE: Do not soak parts in cleaning solutions. Always wipe parts dry of all cleaning solutions. Following
these two recommendations will greatly extend the life of the parts.
NOTE: Any parts cleaned with iodophor solution will stain yellow.
3.1.3 Factors that aect product life
Factor Description
Thermal stress
Operating without the cooling fan running or operating with
clogged lters will reduce LED life.
Light pipe folding or excessive
bending
Do not fold or bend the light pipe any tighter than 60 degrees.
NOTE: To maintain optimal fan perfromance, clean or replace lters when they are dirty.
3.1.4 Cleaning or Replacing the Fan Filter
1. Disconnect power to the unit.
2. Remove the lter retainer from the bottom of the unit.
3. Inspect lter (M1225816). Clean by rinsing in water or replace if necessary.
4. Once the lter is dry, return to the bottom of the unit and reinstall the lter retainer.
24
Chapter 3: Operator’s Maintenance
To Next Page
Loading...
