11.4 Light Shade Replacement
1. Make sure the system power cord is unplugged from the power outlet.
2. Roll the shade sleeve up to access the orange tape underneath and remove the tape (Refer to Figure
11-5 which shows the shade with orange tape removed).
3. Use a pair of small pliers, or any appropriate tool, to grip and remove the plastic pin to release the shade
(Refer to Figure 11-6).
NOTE: When replacing the light shade, make sure to not touch the ber. Residual dirt or grease on the
ber can decrease the light output.
4. Reverse steps to re-install.
Figure 11-5
Figure 11-6
66
Chapter 11: Replacement Procedures
To Next Page
Loading...
