7.4 Installation Procedure
7.4.1 Light Pipe Attachment
1. Make sure that the system is unplugged from the power outlet.
2. Use the provided hex key to remove the top mounting screw on the back plate (Refer to Figure 7-1).
3. Remove the plastic protective caps of the light pipe and the light pipe port. Remove the plastic
protective sleeve of the light pipe mounting clip.
4. Insert the light pipe tip into the light pipe port until the clip is aligned to the top mounting screw hole
(Refer to Figure 7-2).
5. Use the hex key to reinstall the top mounting screw.
Figure 7-1
Figure 7-2
48
Chapter 7: Installation
To Next Page
Loading...
