GE Innova Series - 2285053 - through Bolts with Insert; 2285632 - Floor Plate; Base Plate Assembly

1.3.5 2285053 – Through bolts with insert
Table 2-7:
Item Name Part # Description Quan. Notes
Bolt, Hex 2296892 Through Bolt; M20 - 500-400
12 bolts for Gantry and 4 bolts for
Table
16 pc Through Bolt mounting
method hardware
Washer, Flat 99142204 Special Flat Washer for Through
Bolts; one for each bolt
16 pc same as above
Plate 2290941 Special Steel Spacer Plate; 4 in. x
4 in. (102 mm x 102 mm); one for
each bolt
16 pc same as above
Nut, Hex 99141607 Hex Nut M20 STL galvanized two
for each bolt
32 pc same as above
Grout assy 2285055 - 10 kg Powdered Mortar Ardex
K-15
- RTV Silicon Rubber Adhesive
- 18 mm making tape adhesive
- Open cell foam
1 kit Used in constructing Gantry
grout dam
Dowel 2290937 Wood Dowel; 24 mm diameter 12 pc
Water Elec‐
tric Separa‐
tor
2268647 Manufactured part introduced in
Positioner key hole to fit 1 electrical
conduit of 6”.
1 pc Electrical and water con‐
duits separated inch size.
1.3.6 2285632 – Floor plate / Base plate assembly
Table 2-8:
Item Name Part # Description Quan. Notes
Hex Screws 2360523 Screw M16x30x30 Inox A4-80
Pass
12 pc For floor plate / Base plate
assembly
Washer 99125091 Washer P 17 mm/40 mm 34 pc 24 are used for the position‐
er integration
Hex Screws 99133570 Screw M16x40x40 Inox A4-80
Pass
10 pc 4 only are used for Omega
NOTE: The kit 2285632 Floor plate / Baseplate assembly is needed when the floor plate is
installed. This part isn’t GE part. It’s ordered locally.
Single Plane and Biplane Innova Systems Pre–Installation Kit Installation Procedures
GE Healthcare Direction 2290880-12-1EN, Revision 1
44 1 LC Positioner and Table Floor Preparation Kits