– 44 –
Meat Probe Troubleshooting
Unplug the oven.
y Is continuity present between the oven
control panel circuit board and the 220 volt
power input terminal?
Yes
No
Yes
y Is the circuit breaker open or fuse blown?
Reset the circuit
breaker or replace the
fuse.
No
End procedure.
y Does the touch panel indicate that the
meat probe is functioning?
No
Yes
The meat
probe does
not work.
Yes
Replace the meat probe.
y Does the meat probe work?
No
Replace the oven
control panel circuit
board.
Repair faulty wiring.
y Is there continuity between pin (1) on connector
(CN2) and the terminal on the meat probe
jack?
y Is there continuity between pin (2) on connector
(CN2) and the terminal on the meat probe
jack?
Repair faulty wiring.
Yes
No
To Next Page
Loading...
