Excessivesmoking
GEAppliances.com
Possible Causes What To Do
Excessivesoil.
• On models with touch pads,touch the Clear/Off pad.
On models with an OVENTEMPknob, turn itto OFF.
Open the windows to rid the room of smoke.Wait until
the SELFCLEANlight goes off.Wipe up the excesssoil
and reset the clean cycle.
Ovendoor will not open
after a clean cycle
Oven too hot.
• Allow the oven to cool below locking temperature.
Ovennot clean after
a clean cycle
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled. • Clean up heavy spilloversbefore starting the clean cycle.
Heavilysoiled ovens may needto self-clean again or for
a longer period of time.
Ovendoor will not
unlock fanmodels
with a door latchl
Oven is too hot.
• Allowthe oven to cool below lockingtemperature.
Donot lock the door with the door latch except when
using the self-cleanfeature.
Self-clean light ran The OVEN TEMPknob has not • Set the OVEN TEMP knob to CLEAN. Seethe Using the
some modelsl brinks been set to CLEAN when the self-cleaning oven section.
when trying to set a latch was moved to the right.
self-clean cycle
The latch was not moved to the • Move the latch to the right as far as it will go. See the
right when the OVEN TEMP knob Using the self-cleaning oven section.
was set to CLEAN.
Self-clean light (on A power interruption occurred. • Turn the OVEN TEMP knob to OFF and move the latch
some modelsl blinks to the left as far as it will go. Reset the range controls
during self-clean cycle to the desired settings. See the Using the self-cleaning
oven section.
"Door" appears in the
display (onsome modelsJ
Self-cleaning cycle has been
selected but the latch handle
was not moved all the way
to the right.
• Movethe latch handle all the way to the right.
Latch handle was moved to the
right but a program other than
self-cleaning was selected.
• Movethe latch handle to the right only when setting
the self-cleaning cycle.
"F--" and a number or
letter flash in the display
_'onsome modelsJ
On models with a door latch,
ifa function error code appears
during the self-cleaning cycle,
check the oven door latch.
• The latch may have been moved,even if only slightly,
from the locked position. Make sure the latch ismoved
to the right asfar as itwill go.
You have a function error code. • Touchthe Clear/Off pad.Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. • Disconnectall power to the range for 5 minutes
and then reconnect power. If the function error
code repeats,call for service.
47
)
N
O
r:'
m
O"
ii!iiiiiiliiil
iE{{f!i:i_
Ziillifill
ii:i:_:_ii!iiiii_i!
)
To Next Page
Loading...
