Quick Start 4
LOGIQ
t
200PRO Series Quick Start
2234974–100 Rev. 0
Power On
To connect the system to the electrical supply:
S
Ensure that the wall outlet is a minimum 20 amp dedicated circuit for 120 VAC (USA) or 7.5
amp dedicated circuit for 220–240 VAC (Europe).
S
Make sure that the power switch is turned off.
S
Unwrap the power cable. Make sure to allow sufficient slack in the cable so that the plug is
not pulled out of the wall if the system is moved slightly.
S
Push the power plug securely into the wall outlet.
To power on the system press the Power switch, located to the left of the probe connectors, to
the on(I) position.
I
O
To Next Page
Loading...
Need help?
General
