GE LOGIQ 200 PRO Series User Manual

Quick Start 21
LOGIQ t 200PRO Series Quick Start
2234974–100 Rev. 0
Circumference/Area - Trace (B–Mode)
Perform a circumference/area using the trace method for calculations such as AC,
HC, LVAMd, LVAd and %stenosis.
Press Measurement twice to display a dot “  ” cursor on the screen. The display
on the bottom of the screen shows the circumference in cm.
Use the Trackball to move the dot “  ” cursor to the measurement start point.
Press Set to change the dot “  ” cursor to a “  ” cursor.
Use the Trackball to trace the measurement area. The circumference displayed
on the bottom of the screen will change with the tracing. Press Set to fix the
Circumference value displayed on the bottom of the screen and calculate the
area.
Measurement
Set
Measurement
Set

GE LOGIQ 200 PRO Series Specifications

General

Application	General Imaging
Power Supply	100-240 VAC, 50/60 Hz
Transducer Frequency Range	2.5 MHz - 10 MHz (varies by transducer)
Imaging Modes	B-mode, M-mode
Operating Temperature	10°C to 40°C (50°F to 104°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)