GE LOGIQ C Series - Loading Base Image Software

GE
D
IRECTION 5273008-100, REVISION 9 LOGIQ C SERIES BASIC SERVICE MANUAL
8-4 Section 8-3 - Loading Base Image Software
Section 8-3 Loading Base Image Software (cont’d)
6.) Select one of the options for loading the system. Select choice 1] to load the complete disk.
7.) Press any key to continue when below message display as shown below.
Figure 8-3 Selection for loading the system
WARNINGWARNING
While the software install procedure is designed to preserve data, you should select
choice [2] to format disk C only.
WARNINGWARNING
If software upgrades to R1.1.5 in China, you should select choice [1] to load or upgrade
complete disk.
Figure 8-4 Upgrade continue message