GE MultiLink ML1200

12–10 MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
SPANNING TREE PROTOCOL (STP) CHAPTER 12: SPANNING TREE PROTOCOL (STP)
Configuring STP parameters (continued)
ML1200(stp)##cost port=2 value=20
Setting cost for STP...Successfully set the path cost for port 2
ML1200(stp)##
show stp ports
STP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
-------------------------------------------------------------------------------
01 TP(10/100) 128 100 Forwarding 80:00:00:20:06:2b:e1:54 80:01
02 TP(10/100) 20 20 Forwarding 80:00:00:20:06:2b:e1:54 80:02
03 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:03
04 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:04
05 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:05
06 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:06
07 TP(10/100) 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:07
ML1200(stp)##
port port=1 status=disable
Successfully set the STP status for port 1
ML1200(stp)##
show stp ports
STP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority Path Cost State Des. Bridge Des. Port
-------------------------------------------------------------------------------
01 TP(10/100) 128 100 Forwarding 80:00:00:20:06:2b:e1:54 80:01
02 TP(10/100) 20 20 Forwarding 80:00:00:20:06:2b:e1:54 80:02
03 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:03
04 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:04
05 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:05
06 100MB Fiber 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:06
07 TP(10/100) 128 100 Disabled 80:00:00:20:06:2b:e1:54 80:07
ML1200(stp)##
port port=1 status=disable
Successfully set the STP status for port 1
Since port 9 does not participate in
STP, it is not listed here. Any changes
made to STP parameters on port 9 will
be ignored