GE NX-10

LOC PG DESCRIPTION DEFAULT YOUR DATA
Bright
All lights off
Seg
5
SINGLE SCAN HOLD
FUNCTION (3 Beep)
2
All units off
All lights on
On
Off
Dim
Bright
All lights off
242 26 OPTIONS AND READER PARTITION
Seg
1
SYSTEM OPTIONS 3, 5, 6
"On" if enabled for User Card Programming
"On" if optical tamper enabled
"On" if buzzer follows keypad buzzing
"On" if ding-dong chime enabled (Opt 3 & chime must be enabled)
“On” if an RTE from a scanned card is to be logged as Code Entry
“On” if reader is in NX-1701E Legacy Mode
“On” if an RTE from a zone or the Egress input is to be logged as Code Entry.
“On" if LEDs to extinguish after 2 minutes without a scan
Seg
2
LED1 (GREEN) OPTIONS 1,2
"On" follows system Ready status
"On" to toggle with the Open Collector output
"On" if inverted
Reserved
Reserved
Reserved
Reserved
Reserved
Seg
3
LED2 (RED) OPTIONS 1
"On" follows system Armed status
"On" to toggle with the Open Collector output
"On" if inverted
Reserved
Reserved
Reserved
Reserved
Reserved
Seg
4
READER PARTITION 1,2,3,4,5,6,7,8
"On" if reader is in Partition 1
"On" if reader is in Partition 2
"On" if reader is in Partition 3
"On" if reader is in Partition 4