GE S2020 User Manual

Chapter 7 – Configuration
GE Reason Switches
REASON SWITCHES-TM-EN-3
209
 Specific: indicates that only specified DSCP levels
will be used at this QCE. Values allowed are the
DSCP range values (from 0 to 63);
 Range: indicates that only a range of specified
DSCP levels will be used at this QCE. Values
allowed are the DSCP range values (from 0 to 63)
o Action Parameters: indicates all action parameters to be applied
when frame matches with key parameters. If frames match with all
key parameters configured, then frame will be treated as
configured at the Action Parameters. Possible configuration are as
follows:
 CoS: indicates to which CoS queue incoming frame with
key parameters should be redirected to. Allowed values
are the CoS range values, from 0 to 7;
 DPL: indicates to which DPL level incoming frame with key
parameters should be redirected to. Allowed values are
the DPL range values, from 0 to 3;
 DSCP: indicates to which DSCP level incoming frame with
key parameters should be redirected to. Allowed values
are the DSCP range values, from 0 to 63;
After one of the configurations described before is changed, there are buttons that
allow the user to save or discard the configurations.
o Save: save configuration at the Running Config;
o Reset: undo changes made locally at the Running Config.
11.12 Storm Policing
Storm Policing menu allows configuring storm prevention function. Storm prevention
is a way to implement quality-of-service for a given LAN.
o Port: shows the ports to be configured at this row;
o Unicast Frames: indicates configuration to be applied when
frames are from and to unicast hosts. Possible configuration is as
follows:
 Enabled: enable Unicast Frames policing function at the
port. Checkbox selected means function enabled, and
checkbox empty means disabled;
 Rate: indicates rate to be applied on the storm policing
function at that port. Traffic rates at the port higher than
this field are not allowed if function is enabled. Allowed
values are integer values and limits depend on the Unit
used. Range of 100 to 1,000,000 is allowed when kbps or
fps units are used. Range of 1 to 32,000 is allowed when
Mbps or kfps units are used;

GE S2020 Specifications

General

Brand	GE
Model	S2020
Category	Switch
Language	English