GE S2020 User Manual

GE Reason Switches
Chapter 8 – Monitoring
236
REASON SWITCHES-TM-EN-3
 Software version, which is the current firmware running at
the switch;
 Software date;
 Acknowledgements, where the Details link displays all
open-source codes used by the switch.
 CPU Load
CPU Load option allows user to view graphically CPU usage online of the switch. The
graph has 25%, 50% and 75% percentage bars to guide user about CPU Load, and
graph is updated with the web page. Thus, for online monitoring, it should be
selected the Auto-refresh checkbox at the top of the web page. Time increases from
the left to the right.
Green line refers to a 100 ms average CPU load, blue line refers to a 1 second
average CPU load and magenta line refers to a 10 seconds average CPU load.
 IP Status
IP Status option allows user to view IP interfaces for switch management interfaces,
IP routes configured and the neighbour cache (ARP cache).
o IP Interfaces: shows IP addresses of the management interfaces of
the switch.
 Interface VLAN. If internal interface, the “OS:Io” text is
shown;
 Interface Type, that is, protocol type and version;
 Interface Address;
 Interface Status.
o IP Routes: shows the IP routes switch is allowed to perform. These
routes are only used by the management interface.
 Network of route configured;
 Gateway of route configured;
 Route Status.
o Neighbor Cache: the ARP cache used.
 Neighbors IP Address;
 Link Address of neighbors, that is, neighbor VLAN and
MAC address.
 Log:

GE S2020 Specifications

General

Brand	GE
Model	S2020
Category	Switch
Language	English