Chapter 2 – Safety Information
Use a suitable protective barrier for areas with
restricted space, where there is a risk of electric
shock due to exposed terminals.
Disconnect power before disassembling. Disassembly of the
equipment may expose sensitive electronic circuitry. Take
suitable precautions against electrostatic voltage discharge
(ESD) to avoid damage to the equipment.
NEVER look into optical fibres or optical output connections.
Always use optical power meters to determine operation or
signal level.
Testing may leave capacitors charged to dangerous voltage
levels. Discharge capacitors by reducing test voltages to zero
before disconnecting test leads.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
Operate the equipment within the specified electrical and
environmental limits.
Before cleaning the equipment, ensure that no connections are
energised. Use a lint free cloth dampened with clean water.
Integration of the equipment into systems shall not interfere
with its normal functioning.
The functioning of the device has been certified under the
circumstances described by the standards mentioned in
Error! Reference source not found. (item Type Tests). Usage of t
he equipment in different conditions from the specified in this
manual might affect negatively its normal integrity.
The equipment shall have all their rear connectors attached
even if they are not being used, in order to keep their levels of
ingress protection as high as possible
To Next Page
Loading...
Need help?
General
