D
IRECTION 5813707-100, REVISION 2 VENUE GO™ SERVICE MANUAL
Chapter 4 - General Procedures and Functional Checks 4-25
PRELIMINARY
4-3-7-2-3 Cart Tilt/Swivel Movement Test
Verify cart’s cradle tilt and swivel movement:
1.) Tilt movement:
• Verify forward and backward tilt is possible while system is docked, making sure movement is
smooth reaching end position on both sides.
• Verify the forward scanner tilt is 10°± 2°
• Verify the forward scanner tilt is 40°± 2°
• Verify the scanner tilt force from the scanner sides or upper handle is min: 2.5Kg and max: 4.5Kg
(initiate small movement) while the scanner is mounted on a fully assembled cart.
2.) Swivel movement:
• Bring the cart to the most upper position. Verify left and right swivel is possible until end position
while system is docked, making sure movement is smooth.
• Verify the max horizontal scanner left/right tilt (Swivel) range from forward direction is at least 140°±
5° to each side while the height is higher than 86 cm
• Verify the scanner left or right rotate force from the scanner sides is min: 2Kg and max: 3Kg (initiate
small movement) while the scanner is mounted on a fully assembled cart.
Figure 4-65 Cradle Tilt and Swivel Movement
To Next Page
Loading...
