GE Venue Go - Software Installation Procedure

D
IRECTION 5813707-100, REVISION 2 VENUE™ SERVICE MANUAL
8-66 Chapter 8 - Replacement Procedures
PRELIMINARY
8-3-3 Software Installation Procedure
NOTE: Images in this procedure are for reference only. There may be differences or variations, in accordance
with different software versions.
1.) Plug the Software Installation Media into the USB port located on the Interface Panel of the Venue
Go™ .
2.) Turn on the system.
The opening screen is displayed.
3.) For new installation (after SSD replacement), tap Format SSD and Install.
If patient information is stored on the SSD, perform one of the following:
Select Update SW to install software without affecting user data.
The Warning message appears:
4.) Click Yes in the Warning message box.
5.) Automatic installation process runs. At the end of the process, the following message appears:
Figure 8-148 Venue Go™ Software - Installation Options
Figure 8-149 Venue Go™ SSD Format- Warning Message