Preset
Versana Essential – User Guide 3-15
5759238-100 English Rev. 2
EZBackup and EZMove (continued)
NOTE: EZBackup/EZMove saves data as RAW data. If you import data
to the system, you can modify the image data.
NOTE: To display exported Raw DICOM images on a PC, you need the
dedicated viewer.
NOTE: When backing up or moving reports, do not use EZBackup or
EZMove, EZBackup or EZMove cannot back up or move
reports.
NOTE: “Archived” information is saved to each exam during EZBackup.
When you perform EZBackup, the system backs up the exams
except for the archived exam.
NOTE: EZBackup/EZMove cannot span a single image across two (2)
or more media. Therefore, if EZBackup/EZMove encounters an
image that is greater than the capacity of the media, it skips the
oversized image.
NOTE: EZBackup/EZMove does not store images to media in
sequential order. Instead it maximizes the most amount of
images per media.
NOTE: If the system locks up during the media auto format process,
shutdown the system by holding down the power button and
reboot the system. After the system is up, replace the media to a
new one and execute EZBackup or EZMove again. To avoid
trouble such as data loss, do not reuse the failed media for any
other function.
NOTE: If you try exporting a previously backed-up exam, the message
“Can’t Find Source file” displays. The image data had already
been removed from the hard disk drive with EZBackup/EZMove.
NEVER restore the patient archive from media made previous
to the last move.
To Next Page
Loading...
