GE Vivid E7

GE
D
IRECTION GB091046, REVISION 2 VIVID E9 / VIVID E7 BT’13 SERVICE MANUAL
3 - 44 Section 3-8 - Connectivity setup
3-8-6 Set the Remote Archive’s Network Information
To be able to connect to a remote archive, on a remote computer or server, you must configure
VIVID E9 / VIVID E7 to communicate with it.
In the Remote Archive Setup area of the Tcpip screen (see example in Figure 3-30), enter the;
1.) Remote Archive IP address. (Default IP Address from factory: 10.0.0.4).
2.) Remote Archive Name. (Default Remote Archive Name from factory: ECHOPAC7-000001).
.
Figure 3-30 TCP/IP Set-up for VIVID E9 / VIVID E7
IP ADDRESS FOR THE
REMOTE ARCHIVE
COMPUTER NAME FOR
THE REMOTE ARCHIVE