Starting the System
Voluson
®
730 - Instruction Manual
4-6 105838 Rev. 3
4.5.1 Starting the System
Touch a setting key.
Touching a setting key causes loading of the preset.
The probe is initialized, the main menu (2D mode) appears on the touchpanel and the ultrasound
image appears on the monitor in write mode (real time display).
Pressing the [Freeze] key causes loading of the selected (highlighted) setting.
Same function as when pressing a setting key.
Exit: return to the previously used active mode menu (2D mode,
M mode, .....) without any changes
Note:
Soft key [Exit] and hard key [Probe] provide the same function.
You may exit eventually by one of the keys, if no change of a probe or an application was made.
If a change was made in the “Application” field, the key turns dark (disabled). In this case an exit is
only possible by selecting a setting.
4.5.2 To freeze an Image
Freeze/Run-key (hard key)
Storing of the image by pressing the [Freeze] key:
Bright key:
read mode (image is stored, probe deactivated)
Dark key:
write mode (real-time is on, probe activated)
To Next Page
Loading...
