GE RAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
5-70 Section 5-17 - LINUX - Voluson Maintenance System
5-17-5-3-1 BIOS “Boot Priority Order” Setting
NOTE: Depending on the installed PC-Motherboard version, different BIOS versions are available. The
displayed screens may slightly differ from images shown in this manual.
1.) Insert the System DVD into the DVD Drive.
2.) Turn system off and then back on.
3.) During startup, press the DEL key immediately, to enter the BIOS Setup.
4.) Enter the BIOS password: polaris (case sensitive) and then press Enter.
5.) Use the “Arrow” keys [<-] or [->] on the alphanumeric keyboard to select the [Boot] tab.
6.) Using the keys [PgUp] (Arrow up) and [PgDn](Arrow down) on the alphanumeric keyboard select
Set Boot Priority and then press Enter.
General operation and selection in BIOS and LINUX menu is done with:
• the alphanumeric keyboard
• the “Arrow” keys [left] , [right] , PG UP
[up] , PG
DN [down] and
• the “Enter” key on the keyboard
To Next Page
Loading...
