GE Voluson P6 BT16 - Section 8-22 Replacement of the MONITOR ARM; 8-22-1 Manpower; 8-22-2 Tools; 8-22-3 Removal Procedure

GE DRAFT VOLUSON™ P8 / VOLUSON™ P6
DIRECTION 5723243, R
EVISION 6 DRAFT (MAY 23, 2018) BASIC SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-69
Section 8-22
Replacement of the MONITOR ARM
8-22-1 Manpower
Two persons, 20 minutes
8-22-2 Tools
Philips screwdriver, Nipper, Allen Wrench
8-22-3 Removal Procedure
1.) Disassemble the LCD MONITOR. Refer to the Section 8-21 "Replacement of Monitor" .
2.) Unscrew 1 screw to remove Monitor arm cover. Refer to the figure below.
3.) Removing 2 RUBBER CAPS on SPEAKER COVER LFET/RIGHT.
Figure 8-94 Removing the LCD Arm Cover
Figure 8-95 Removing 2 RUBBER CAPS on SPEAKER COVER LEFT/RIGHT
MONITOR ARM
COVER