8
Connecting the main keypad and the light socket cable
Note: always shut power down before connecting an accessory to the pack.
To connect the keypad, insert the in.link connector into
the appropriate keypad connector (as illustrated).
To connect the light socket cable, insert the MTA
connector into the 12 V DC light output connector P33
(as illustrated).
Remove the cover screws from the front of the pack with a Phillips screw driver.
Remove and put aside the strain relief bracket and the foam gasket located in the molded strain relief channels.
Preparation
Keypad
Connect the main keypad
as indicated here.
Keypad conduit
Light socket cable
Part number:
Light socket cable - 9920-400489
Foam gasket
Molded strain relief channels
Route the low voltage cables through the molded strain relief channels on the bottom of the spa pack.
Strain relief bracket
Connections
To Next Page
Loading...
Need help?
General
