Geeetech Rostock 301 Building Instruction

www.geeetech.com
Page 16
ShenZhen GETECH CO.,LTD
Spacer
#39
4
M3 x 12 Screw
#20
4
M3 washer
#5
4
Step 1. Plug the aircraft-type spacer (#39) into the 4 screw holes on the underside
of the control board (#55).
Step 2. Attach the control board (#55) to the base plate (#A2) with 4 M3 x 12
Screws (#20) and m3 washers (#5).

Geeetech Rostock 301 Specifications

General

Brand	Geeetech
Model	Rostock 301
Category	3D Printers
Language	English