Geemarc combi dect 295 - Delete the Entire Redial List; 4.12 Find the Handset

26
4.11.4 Delete the Entire Redial List
Using a handset:
1. Follow Steps 1 and 2 in section 4.11.1.
2. Press and / to select DELETE ALL.
3. Press to confirm.
4. Press to reconfirm.
Using the base:
1. Follow Steps 1 and 2 in section 4.11.1
2. Press MENU/OK and / to select DELETE ALL?
3. Press MENU/OK to confirm.
4. Press MENU/OK to reconfirm.
4.12 Find the Handset
This feature helps you find the misplaced handset(s).
You can locate the handset by operation on the base station as below.
1. In idle mode, press MENU/OK and / to select PAGE ALL HS.
2. Press MENU/OK to confirm. “PAGING” will flash on the base screen.
All the handsets registered to the base will produce the paging tone, and “PAGING” will
flash on the screen. You can stop the paging by pressing / / /
CANCEL/MUTE on any handset or INT/MUTE/CLEAR on the base to stop paging.
NOTE:
If there is an incoming call during paging, the phone will ring with the incoming call
instead of paging.
USE YOUR PHONE