owner's manual
genesys xp
The recording studio section Page93
NAVIGATION DATA INPUT
ENTER MENU
MOVE
The function MOVE shifts events from one point of the selected track to another.
PARAMETERS:
FROM LOCATOR - TO LOCATOR Determines the start and end point of the part to move. It is possible to specify the
measure, beat and resolution (tick). Assignable values: within the limits of the Song. It is not possible to specify a point before
the start or after the end of the Song.
START LOCATOR Determines the new position of the part that is to be moved. Assignable values: any point of the song.
COPY
F3 Track Single track. Select the
track with the function
buttons A-H.
F4 Master track The MasterTrack
records events
pertaining to the
general controls of the
Song (Tempo, Time
Signature, selected
Performance, selected
effects).
F5 Chords track Copy track for the
chord symbols
inserted in the score.
F6 Music track Copy track for the
notes of the score
(standard notation
F7 Lyrics track Track for the lyrics of
the score.
F8 All tracks
The COPY function copies events from a single track or from all tracks.
FUNCTION BUTTONS
Use the Soft buttons F1...F8 to select
the track from which events will be
copied. Depending on the type of track
selected, the following parameters will
appear or not.
COPY MODE
Determines the copy mode. MERGE
unites the copied events to those
already present at the destination.
REPLACE substitutes the events present
at the destination with those copied.
Options: Merge, Replace.
FROM-TO-TRACK
Specifies the source and destination
track of the copy. The «From track...»
part is selected with the function
buttons A ... H. The “TO TRACK” part
is modified with the DIAL. Assignable
values: any track (1...32).
TO SONG
Determines the destination Song for
the copy. If the selected Song is non
existent, it will be created by the act
of confirming the copy command.
Values range: any Song (1-16).
NOTE RANGE FROM..TO..
Determines the highest and lowest limits
of the note range to copy. To copy a
single percussive instrument from the
Drum track, assign the same value to
the “from” and “to” parameters. For
example, to copy the snare (D2), set the
pa-rameter as «Note range from D2 to
D2». Values ranges: C-1-G9.
START LOCATOR
Defines the new position of the
copied part. Values range: any point,
even after the end point of the Song.
START LOCATOR
Specifies the number of consecutive
copies. Each copy starts exactly where the
previous one ends. Values range: 1-998.
To Next Page
Loading...
Need help?
General
