owner's manual
genesys xp
To use the genesys xp as a stand alone unit Page25
In this chapter we analyse some easy-to-use and easy edit procedure based on the Genesys xp sequencer. The edit operations
regards only some global aspect of a song, not the MIDI event editing. Please refer to the specific chapter in this manual.
Use the Genesys xp sequencer to edit MIDI songs
Operations:
During your realtime performance some of the files you direct play may need some editing: global key, mixing parameters,
change of some sounds. These operations are made possibile by loading the song in the Genesys xp sequencer, then execute
the edit and save the edited song in the hard disk.
Genesys
Gem WK series songs (except WK2)
Standard MIDI Files GM1 & 2 + Lyric (Tune 1000 format)
GEM WX song files
Load a Song in the internal memory1
2
Execute the editing procedure
3
Store the editing
4
Save the edited song in the hard disk
• The MIDI file formats you can load in Genesys xp sequencer (RAM file memory):
Genesys xp MIDI sequencer:
Genesys xp MIDI sequencer:
•Up to 64 different songs
•Each song can contain up to 32 tracks
•250.000 events in total
•Mixing & editing parameters
•4 effects with separate sends in two blocks
Press the DISK button in the panel
1
Load a Song from a driver (Floppy, CD Rom, Hard disk) to the sequencer
Select the driver where you want to load the song
2
Locate the song
3
The disk drive's main page appears in the screen
Locating the song folder the LOAD function is enabled
Press the function button F1 LOAD, then ENTER
4
To change the key1
2 Edit volume levels
3 To change a sound
EXAMPLES
To Next Page
Loading...
Need help?
General
