GEM genesys xp

Realtime use of the Genesys xpPage60
owner's manual
genesys xp
NAVIGATION ENTER MENU
Multiped 1
Multiped 2
Multiped 3
NAVIGATION DATA INPUT
Press ESCAPE from the previous page, select the PEDAL MENU with the cursor then press ENTER.
The pedal programming page appears in the display. From this menu you can set the pedal programming and assign the
current preset.
Off No effect
Pitch Bend Applies Pitch Bend to the notes. The Pitch Bend sweeps from the maximum
negative to maximum positive. The central position of the continuous pedal
corresponds to 0 pitch.
Pitch + Increases the Pitch
Pitch – Decreases the Pitch
Filter Opens/closes the Filter Cutoff parameter
Resonance Affects the Resonance parameter
Modulation Generate modulation data message (CC01)
Breath Cnt. Generates Breath controller message (CC02)
Volume Controls the general volume (CC07)
Pan Controls the Pan (CC10) from left to right.
Expression Controls the volume from 0 level to the maximum settings of the mixer levels.
Vocal G.
Volume
Controls the volume of the Vocal harmony track using the Vocal Genius
ASSIGNABLE CONTINUOUS CONTROLLER
Is the current page where
you assign the functions to
your pedal
F1 PEDAL PROG.
CONTINUOS SWITCH
ASSIGNABLE SWITCH CONTROLLER
Off No effect
Damper Applies the sustain effect to the released notes.
Sostenuto Sustains only the notes played at the time of pressing the pedal; notes played
after pressing the pedal are not affected.
Soft Attenuates the sound.
Start/Stop Simulates the Start/Stop button.
Synchro Enable /disable the syncro function
Intro Activates the Intro.
Fill < Activates the Fill< function.
Fill = Activates the Fill function.
Fill > Activates the Fill> function.
Ending Activates the Ending function.
Variation 1 Switches to Variation 1.
Variation 2 Switches to Variation 2.
Variation 3 Switches to Variation 3
Variation 4 Switches to Variation 4.
Var > Switches to the next Variation.
Var < Switches to the previous Variation.
Memory> Advances to the next memories
Memory< Advances to the previous memories
Harmony Activates/deactivates the Harmony function
Bass Inv. Enables/disables the Bass inv. function
Arrange On/Off Activates/deactivates the Arranger
Fade In/Out Activates/deactivates the Fade In/Out function.
Tempo > Increases the Tempo setting by one unit at a time.
Tempo < Decreases the Tempo setting by one unit at a time.
Punch Activates/deactivates the Punch recording function during recording operations.
Rotary s/f Changes the speed of the Rotary effect from Slow to Fast or vice versa.
Minor Converts the currently held chord to the minor chord.
Dim Converts the currently held chord to the diminished chord.
Min 7th Converts the currently held chord to the minor 7th chord.
Maj 7th Converts the currently held chord to the Major 7th chord.
Voc. Genius on/off Enable/Disable the vocal processor
Freeze Chord Locks the current chord (pedal held), allowing you to play freely with both
hands across the entire key-board without triggering changes in the Style
auto-accompaniment. The function deactivates at pedal release.
Selects the pedal assign
function page
F2 PEDAL ASSIGN
Allows to program the
pedals special MULTIPEDAL
mode.
F3 - F5 MULTIPEDAL
CONTINUOS
CONTROLLER PEDAL
ASSIGNABLE
SWITCH PEDAL
MULTIPEDAL