Gemalto Prox–DU Installation Guide

Computer Installation Guide
Prox–DU & Prox–SU
www.gemalto.com
DOC119735A Public Use Page 49/59
Checking the smart card detection
To check if the Prox–DU or the Prox–SU reader/writer is able to detect contactless smart
cards put a smart card near the reader/writer’s antenna:
The blue LED should be set to an enlightened state.
Figure 42 – Contactless smart card check
Note: The blue LED should return to the blinking state after a short time depending on the
computer operating system. The smart card used for the check should be of course
ISO14443–A or ISO14443–B compliant. Otherwise, no LED change will occur.
To check if the Prox–DU reader/writer is able to detect contact smart cards insert a smart
card into the reader/writer’s slot:
The yellow LED should be set to an enlightened state.
Figure 43 – Contact smart card check
Note: The yellow LED should return to the blinking state after a short time depending on the
computer operating system. The smart card used for the check should be of course
ISO7816-3 compliant. Otherwise, no LED change will occur.
The second test is not available for the Prox–SU model.

Gemalto Prox–DU Specifications

General

Brand	Gemalto
Model	Prox–DU
Category	Card Reader
Language	English