第 5 页 共 16 页
2.1.6 One-Shot-Sewing key
Use key: select/non-select one-shot-sewing. LED on top left side of the one-shot-sewing key will be
lit if one-shot-sewing is selected during enable multi-segment, as ；otherwise, LED off, as 。
2.1.7 Stop position key
Use key: select up/down stop position. LED on top left side of this key will be lit if select down
needle position, as ；LED off if select up needle position, as 。
2.2 Technician Mode
In this mode, technical parameters corresponding to various functions can be adjusted or reset
according to practical needs so that the system may run in the best condition. Parameters setting under
technician mode:
Step 1: Under operator mode, press key and key, the LCD will display PD - 0000, and then set
the password by technician. The default password is 0000, and LCD display
as .
Step 2: Use （6-13）keys to input the password, and then
press key. If the password is correct then enter technician mode, otherwise, it will return to
operator mode.
Step 3: Change technician parameters by （4、5）keys and key. The parameters are shown
in table 2.
Step 4: Parameters values can be changed by （6-13）keys.
Step 5: Under technician mode, press key, the panel will return to operator mode.
Table 2: Technician mode parameter：
To Next Page
Loading...
