第 9 页 共 16 页
Parameter
High byte
Parameter
Low byte
Default Rang Comment
4 90 0 ~1024
Pedal trimming position set, See 2-1.
（the value is not higher than the parameter [30]）
5 300 0 ~1024
Press foot lifting, See 2-1.
（the value is between[34]and[36].）
6 460 0 ~1024
Pedal back mid position，see 2-1.
（the value is between[35]and[37].）
7 480 0 ~1024
Pedal step upon running position，see 2-1.
（the value is between[36]and[38]）
8 680 0 ~1024
Pedal low speed running position（upper）,see 2-1
（the value is between[37]and[39]）
9 960 0 ~1024
Pedal simulation the largest of value, see 2-1
（the value is not lower than the parameter [38]）
A 100 0 ~800 Pedal press foot lifting confirm time
0 1
0／1
Run to up needle position after Power on：
0: no action 1: action
1 1
0／1
Automatically reinforcing functions chose ：
（the machine head is not automatically
reinforcing functions, the best way is prohibit）
0：prohibit 1：allow
2 0
0／1
Back to sewing by hand when the function mode
selection:
0：Juki mode. In sewing or in the end of the action
1：Brother mode. It acts only in sewing.
custom setup
4
3 0
0／1／2／3
Special Running Mode setup：
0：operator select
1：simple sewing mode
2：calculate initial angle of motor (do not uninstall
strap)
3：calculate motor/machine head run rate mode
(synchronizer, do not uninstall strap)
To Next Page
