To Next PageTo Next PageWhat to do if the no load voltage frequency falls off on my Generac Power Systems XT8000EFI Portable Generator?
First, verify that the rotor is spinning. Then, proceed to problem 3 for further troubleshooting steps.
General| Model | XT8000EFI |
|---|---|
| Type | Portable Generator |
| Engine Type | 4-Stroke OHV |
| Engine Displacement | 420 cc |
| Starting System | Electric Start |
| Fuel Type | Gasoline |
| Run Time at 50% Load | 11 hours |
| Weight | 206 lbs |
| Voltage | 120/240V |
| Frequency | 60 Hz |
| Wheels | Yes |
| Rated Wattage | 8000W |
| Surge Wattage | 10000W |
| Fuel Tank Capacity | 7.5 gal |
| Outlets | 1 x 120/240V 30A |
Defines DANGER, WARNING, and CAUTION hazard symbols used in the manual.
Explains operation and guides through AC output troubleshooting flowcharts for brush types.
Covers checks for voltage, breakers, receptacles, and basic component tests.
Introduces EFI principles, fuel system, sensor inputs, and fault codes.
Covers starting, running, and idle issues with diagnostic steps.
