Generic Trigger SM 50ccm User Manual

- 25 -
Gear mobile oil
Inspection
*Attention
Fuel check, let down the middle supporter to be
perpendicular to motorcycle on the flat floor.
Dismantle the inspection bolt of gear oil after stopping engine.
The oil level is below the lower limit of bolt hole is good.
Please supplement gear oil when the oil level is too low.
Install the inspection bolt of gear oil.
*Attention
Confirm the airtightness of bolt and whether it is out of
clutch and damage.
Changing gear oil
Dismantle the inspection bolt of gear oil.
Dismantle the oil drain bolt, the gear oil will effuse.
Install the oil drain bolt.
*Attention
Confirm the airtightness of bolt and whether it is out of
clutch and damage.
Supplement gear oil.
Check the oil leak of each position after operation.
Driving chain
Dismantle oil seal, check whether the fringe of oil seal is
broken.
Check whether the rear wheel bearing is broken and take
out the bearing.
Take out the bush and dismantle the rear driving chain and
the bolt of chain wheel.
Check whether the rear driving chain and chain wheel
exceeds the extreme dimension.
Driving chain
Chain wheel
stand
Right cover
Oil drain bolt
Right cover
Oil drain bolt

Generic Trigger SM 50ccm Specifications

General

Brand	Generic
Model	Trigger SM 50ccm
Category	Motorcycle
Language	English