- 112 -
14.3.2.1 Inspection
Open the water tank cover and inspect the cooling liquid
volume in the tank.
When the volume reaches certain limit, cooling liquid
should be appended.
If the radiating fins are crushed or distorted, cooling
capacity of the radiator will decrease.
When more than 1/3 of the radiating fins are crushed or
distorted, trim them with a small pin.
Inspection of the liquid in the radiator：
Confirm the liquid has adequately cooled down before
dismantling the radiator cover；
Eject all cooling liquid out;
Gradually inject the formulated cooling liquid through the
filling hole（mounting hole of the radiator）till reaching the
margin of the filling hole.
Mount the radiator cover.
Note：Please use the cooling liquid produced by Generic
Company，the lowest service temperature of which is - 35
cooling liquid
margin
To Next Page
