Genesis GV80 - Page 446

07
7-111
Information
• Driving Speed Limit helps you drive
below 40 mph. At this time, the vehicle
decelerates due to the vehicle ahead.
After the vehicle has decelerated, it
cannot automatically accelerate.
• Driving Speed Limit will cancel in the
following circumstances:
- When the driver grabs the steering
wheel again
- When the driver turns on Lane
Following Assist by pressing the
button
- When Smart Cruise Control switch
(+, -,
) or button is pushed, or
the accelerator pedal or the brake
pedal is depressed
Highway Lane Change Assist (if
equipped)
Function display and control
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to “View Modes” section in chapter
4.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the system.
Ready/OperatingReady/Operating Standby/CancelledStandby/Cancelled
OJX1070104E OJX1070104E OJX1070103EOJX1070103E
(1) Highway Lane Change Assist
indicator
• Green on : Ready state
• Green
blink : Operating state
• White
on : Standby state
• White blink : Cancelled state
(will illuminate for a certain period
of time)
(2) Green lane line
The green lane line is displayed when
the function starts operating, and until
the vehicle steps on the lane line.
(3) Green arrow
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4) Message
• Message is displayed when the
function does not operate even
though the turn signal switch is
used.
• Message is displayed when the
function is cancelled whilst
operating.