07
7-113
Function operating
Turn signal leverTurn signal lever
OJX1050280EOJX1050280E
[1] : Centre
Highway Lane Change Assist function
will operate, when you push the turn
signal lever up or down to the B position
whilst the function is in the ready state
(
indicator is green), and all of the
following conditions are satisfied:
• The driver has his/her hand on the
steering wheel
• There is no collision risk in the
direction of lane change
• There is a single dotted lane line in the
direction of lane change
• There are no Forward Collision-
Avoidance Assist and Blind Spot
Collision-Avoidance Assist warnings
• The vehicle is driven in the middle of
the lane
• The road you are driving on, or the
road you are about to change lane is a
road that the function can operate
Information
• When the turn signal lever is placed at
B position for a certain period of time,
the green arrow will appear. At this
time, even when the lever is released
and returns to it’s original position (1),
lane change will still be assisted.
• Whilst lane change is being made by
the function, the turn signal indicator
will blink even when the turn signal
lever is not held, and the turn signal
indicator will turn off when lane change
is complete.
)XQFWLRQVWDQGE\
Highway Lane Change Assist function
will be in the standby state when one of
the ready state condition is not satisfied,
or when entering or driving on one of the
following roads:
• Road within a certain distance from
the tollgate on the main road of the
highway (or motorway)
• The road ahead ends without an
interchange or junction
• Road with sharp curves
• Road with narrow lanes
• Road that is under construction
To Next Page
Loading...
Need help?
General
