Genesis GV80 - Page 498

07
7-163
How to cancel Exit function whilst
operating
• Press the Parking/View ( ) button
in the following stage:
- Checking space
- Select exit direction
• Shift the gear to R (Reverse) in the
following stage:
- Checking space
- Select exit direction
• Press the Parking Safety (
) button
or select ‘Cancel’ on the infotainment
system screen to turn off Exit
function.
• Whilst Smart Exit function is
operating, if the vehicle is stopped by
depressing the brake pedal, and the
gear is shifted, Exiting function will
turn off. At this time, EPB (Electronic
Parking Brake) will not be engaged.
The function will pause in the following
conditions when:
• There is a pedestrian, animal or object
in the direction the vehicle is moving
• The driver’s seat belt is not fastened
• Blind-Spot Collision-Avoidance Assist
or Rear-Cross Traffic Collision Assist
operates whilst the vehicle is being
controlled in the reverse direction
• The Parking/View (
) button is not
continuously pressed
• The vehicle is stopped by depressing
the brake pedal
When Exit function is paused, the vehicle
will stop. If the condition that made
the function to pause disappears, the
function may operate again.
The function will cancel in the following
conditions when:
• Smart Exit
- The steering wheel is steered
- The gear is shifted whilst the vehicle
is moving
- Operating EPB whilst the vehicle is
moving
- The engine bonnet is open
- Vehicle speed is above 3 mph
- Rapid acceleration occurs
- Vehicle skid occurs
- The wheel is stuck by an obstacle
and cannot move
- There are pedestrians, animals or
objects at the front and rear of the
vehicle at the same time
- Approximately 3 minutes and 50
seconds have past after Smart Exit
function has started to operate
- The driver opens the door without
the seatbelt unfastened
- The slope of the road exceeds the
operational range
- The steering wheel, gearshift,
braking, and drive controls are not
working normally
- The function was paused for more
than 1 minute
- ABS, TCS or ESC system operates
due to slippery road conditions
When Smart Exit function is cancelled,
the vehicle will automatically stop, shift
the gear to P (Park) and engage EPB
(Electronic Parking Brake).