➔ Not performing modules registration will cause
that they will be not supervised by the panel, the
panel will not respond to modules tamper and the
panel will not store their individual settings (like
keypad display brightness).
• Panel programming using the keypad is described in
the section: „Programming without computer”
• To quit service mode, it is necessary to enter:
Or select Quit service mode in the Menu.
After quitting from the service mode, the general LED
indicator will stop lighting Orange.
NOTICE
➔ If there will be an alert indicator, check system sta-
tus to find out the cause.
➔ System state checking is available as one of the
„User menu functions”. User menu access requires
authorization with code - both Installer and Master
user code may be used.
➔ To find out system status it is necessary to enter
User Menu:
then select System state information function -
icon , and accept the choice with the key.
To Next Page
Loading...