www.geniecompany.com 01-14 4.1
The Rolling Steel Door Operator can be assembled for right-hand or
left-hand (Each model can also be
Section 4: Installation
Rolling Steel Doors
Front of Hood Installation
1) Remove wall mount brackets from operator. Attach rolling steel mounting
brackets to the operator using the fasteners provided.
Figure 1.
Figure 1
NOTE:
On Jackshaft units, release cable must be installed on operator
before unit is installed.
mounting Front of Hood.
wall mounted.) Typical mounting arrangements are shown.
2) Attach Operator to Powerhead Support bracket using the fasteners
provided. Figure 2.
5/16-18 X 3/4 CARRIAGE BOLT
& 5/16-18 FLANGE NUT
(QTY 6 EACH)
ROLLING STEEL
MOUNTING BRACKETS
Figure 2
5/16-18 X 1-1/4
CARRIAGE BOLT
(QTY 4 EACH)
USE THIS SET
OF HOLES
5/16-18 FLANGE NUT
(QTY 4 EACH)
USE THIS SET
OF HOLES
POWER HEAD SUPPORT
BRACKET
To Next Page
Loading...
Need help?
General
