Adjusting the Speakers
FADE:
Turn this knob to move the sound between the
front and rear speakers.
BAL:
Turn this control behind the
FADE
knob to move
the sound between the right and left speakers.
Playing
a
Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long
on
each side. Tapes longer than
that are
so
thin they may not work well in this player.
The longer side with the tape visible should face
to
the
right. If you hear nothing or hear just a garbled sound, it
may
not
be
in
squarely.
Press
STOP
or
EJECT
to
remove the tape and start over.
Once the tape is playing, use the
knobs
for
VOL,
FADE
and
BAL,
just as you do for the radio. The lighted
arrows
show which side of the tape
is
playing.
MTL:
Your
bias is set automatically. MTL will appear
on
the display when a metal or chrome tape is inserted.
FF:
Press this button to advance rapidly to another part
of the tape. Press
FF,
RCL
or STOP
to
return to playing
speed.
If
you press RCL, the tape will also change sides.
REW
Press this button to reverse the tape rapidly. Press
REW,
RCL or STOP to return to
playing
speed.
If
you
press RCL, the tape will also change sides.
NXT
Press this button to
go
forward to the beginning
of
the next selection. Press NXT again or press RCL,
or
STOP to cancel this function.
If
you press
RCL,
the tape
will also change sides.
PRV:
Press this button
to
go back to the beginning of
the last selection. Press the button again
or
press RCL,
or STOP
to
cancel this function.
For
NXT
and
PRV
to
work properly, your tape must
have at least three
or
four
seconds
of
silence between
each selection.
If
you press RCL, the tape
will
also
change sides.
RPT
Press this button to go
to
the beginning
of
the
selection
and
play
it
again.
Press
RPT
again to cancel
this function.
3-13
To Next Page
Loading...
Need help?
General
