Flash-to-Pass
With the lever in the low-beam position, pull the lever
towad
you
to
momentarily switch to high beam (to
signal that you are going to pass). When you release the
lever, the headlamps will return
to
low-beam operation.
Windshield WipedWasher Lever
The lever on the right side
of
the steering column
controls the windshield wipers
and
washers.
Move the wiper switch to the position
you
want:
OFF:
The wipers are
off.
INT
Intermittent wiper operation.
In
light rain or snow,
you might want to use this position rather than
continuous wiping.
LO:
The wipers will run continuously at low speed.
HI:
The wipers will run continuously at high speed.
For a single wiping cycle, pull the lever toward
you.
Hold
it
there until the wipers start, then let
go.
The
wipers
will
stop
after
one cycle.
If
you
want
more
cycles, hold the lever longer.
Be sure
to
clear ice and
snow
from the wiper blades
before
using
them.
If
they’re frozen
to
the
windshield,
carefully loosen or thaw them.
If
your blades do become
damaged, get new blades
or
blade inserts.
Heavy snow or ice
can
overload your wipers.
A
circuit
breaker
will
stop them until
the
motor
cools.
Clear away
snow or ice
to
prevent an overload.
2-30
To Next Page
Loading...
Need help?
General
