Using Foam-Type Cleaner on Fabric
1.
Vacuum and brush the area to remove any
loose dirt.
2.
Always clean a whole trim panel or section. Mask
3.
Mix Multi-Purpose Powdered Cleaner following
surrounding trim along stitch or welt lines.
the directions on the container label.
4.
Use suds only and apply with a clean sponge.
5.
Don’t saturate the material.
6.
Don’t rub it roughly.
7.
As soon
as
you’ve cleaned the section, use a sponge
8.
Rinse
the
section with
a
clean, wet sponge.
9.
Wipe
off
what’s left with a slightly damp paper
to
remove
the
suds.
towel or cloth.
10.
Then dry
it
immediately with a blow dryer.
11.
Wipe with a clean cloth.
Using Solvent-Type Cleaner on Fabric
First, see if you have to use solvent-type cleaner at all.
Some spots and stains will clean
off
better with just
water and mild soap.
If
you need
to
use a solvent:
Gently scrape excess soil from the trim material with
a clean, dull knife or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth). Cleaning should start at the outside of
the stain, “feathering” toward the center. Keep
changing to a clean section of the cloth.
When you clean a stain from fabric, immediately
dry the area with a blow dryer to help prevent
a
cleaning ring.
Fabric Protection
Your Geo has upholstery that has been treated with
Scotchgard” Fabric Protector, a 3M product.
It
protects
fabrics by repelling oil and water, which are the carriers
of
most stains. Even with this protection, you still need
to
clean your upholstery often
to
keep
it
looking new.
Further information on cleaning
is
available
by
calling
1-800-433-3296 (in Minnesota, 1-800-642-6167).
6-49
To Next Page
Loading...
Need help?
General
