CAUTION
Reflected beams aimed at reflecting surfaces
Potential hazards are not only related to direct beams but also to reflected beams aimed at
reflecting surfaces such as prisms, windows, mirrors, metallic surfaces, etc.
Precautions:
▶
Do not aim at areas that are essentially reflective, such as a mirror, or which could emit
unwanted reflections.
▶
Do not look through or beside the optical sight at prisms or reflecting objects when the
laser is switched on, in laser pointer or distance measurement mode. Aiming at prisms is
only permitted when looking through the telescope.
Pav = 4.8mW λ = 658 nm tp = 800ps
IEC 60825-1:2014
Complies with FDA performance standards for laser products except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
123456
S.No. :
123456
Art.No.:
Equip.No.: 1234567
Power:
11.5-13.5 V ,1.4 A max
GeoMax AG
CH-9443 Widnau
Manufactured: 20X X
Made in Singapore
Zoom90...
Type:
9828_003
1.6.4 Red Laser Pointer
The laser pointer built into the product produces a visible red laser beam which emerges from
the telescope objective.
The laser product described in this section is classified as laser class 3R in accordance with:
•
IEC 60825-1 (2014-05): “Safety of laser products”
Labelling
General
12 Safety Directions
To Next Page
Loading...
Need help?
General
