20.1.5 Tampering Alarm
Note this function is not available for PTZ Camera and PT Camera.
The Tampering Alarm is used to detect whether a camera is being
physically tampered. An alarm can be generated when the camera is
moved, covered up, or out of focus. The alarm approaches include the
triggered output device and e-mail alert. To have the tampering alarm, first
set up these alarm approaches properly:
• To trigger the output device when a tampering event occurs, enable
the output setting and select
Tampering Alarm. See 20.2.2 Output
Settings.
• To trigger the e-mail alert when a tampering event occurs, enable the
e-mail setting and select
Tampering Alarm. See 20.3.1 E-Mail.
Figure 20-8
304
To Next Page
Loading...
Need help?
General
